SERIBOND–WSR–1830 resin is a unique chemistry. This versatile product is specially designed to perform critical tasks in towel, napkin and facial grades. Promotion or improved retention of polyamide wet strength resin Enhancement of Functional performance of the sheet with higher wet strength, dry strength, and improved Wet-Over-Dry Restoring Wet End Charge Balance, especially on machines that run close to or in the cationic range

Specification
Appearance: Liquid, clear to slightly hazy
Solid: 29 – 30 %
Density: 1.05 g/cm3
Viscosity @ 250C: 2,300 – 6,300 cps
PH Value: 3 – 3.5
Ionic nature: cationic
Solubility: Easily soluble in water

Application
SERIBOND–WSR–1830 resin is designed to be added after the polyamide wet strength resin at a point of good mixing. It is important that the SERIBOND–WSR–1830 resin is thoroughly mixed with the stock. Addition of SERIBOND– WSR–1830 to either the thin or thick stock is acceptable, depending upon the polyamide wet strength resin and other cationic additives dosage points and program objective.

Typical dosage level for the SERIBOND–WSR–1830 is 0.05 to 0.1 % on fiber, dry solids basis.

Packing:200 Kgs Drums

Storage & Handling:Storage must be in covered place. Carboys should be kept tightly closed when not in use.

Safety: Handle with care. Before and during use, observe all safety labels on packaging and paint containers, consult Material Safety Data Sheets and follow all local or national safety regulations. Avoid inhalation, avoid contact with skin and eyes, and do not swallow. Take precautions against possible risks of fire or explosions as well as protection of the environment. Apply only in well ventilated areas.
Disclaimer: The information in this document is given to the best of Serix’s knowledge, based on laboratory testing and practical experience. Serix’s product are considered as semi-finished goods and as such products are often used under conditions beyond Serix’s control. Serix cannot guarantee anything but the quality of the product itself. Minor product variations may be implemented in order to comply with local requirements. Serix reserves the right to change the given data without further notice. Users should always consult Serix for specific guidance on the general suitability of this product for their needs and specific application practices